Boiler Supplier

After the scale appears, the thermal conductivity is only 0.5% of the metal. After the boiler burners for commercial scale appears, if the heat efficiency of the scale is reached, the temperature of the heating surface inside the boiler can only be increased. For example, when the wall temperature is 250 °C, When the scale is 1mm, if the same thermal effect is to be achieved, the wall temperature will increase to 650 ° C. At this time, the heat absorption rate is extremely low, the energy consumption is increased, and the fuel cost is doubled.

Hot water boiler burners for commercial heating industry is our essential equipment, gas hot water boiler water provided by the party fast flotilla, high thermal efficiency direct savings on fuel costs of inputs for our company, the intelligence facilities let the boiler run more convenient and effective to reduce the labor intensity of fireman people. --customer feedback

Basics 1 boiler burners for commercial maintenance, gas-fired boiler during operation Note the following points: (1) does not allow pressurized combustion gas boiler or furnace smoke, easy to burn out because stoker hole cover. Not on the bottom of the water (2) Gas boiler ground surface to prevent moisture corrosion. 2, gas boiler run every 2-3 weeks, should be checked once. 3, gas boiler run every 3-6 months after the shutdown should conduct a comprehensive inspection. (1) on the inside and outside gas boiler inspection, such as pressure welds, corroded steel inside and outside part of the phenomenon, if found should be repaired in a serious flaw, if the defect is not serious next time also to be shutdown to repair, if found when there is suspicious, but does not affect safety, records should be made for future reference. (2) can be checked and the water boiler primer coating to prevent corrosion. 4, gas boilers and boiler base paint at least once a year. 5, maintenance of gas boiler normally unused methods: dry and wet two kinds, one month shutdown, care should be taken dry method, wet shutdown can be less than one month regimen. (1) Dry regimen: the boiler furnace shutdown to discharge water, the inside completely remove the dirt, rinse, drying in the furnace with Weihuo (be careful not to fire), and a diameter of 10-30 millimeters block quicklime installed sub-plate, placed in the drum, without contacting the metal with lime, quicklime weight, calculated to the drum 8 kilograms per cubic meter volume, and then all of the manhole, the pipe valve closed hand holes, each of three months, check again, such as lime ingredients like broken, i.e. the need to replace, should be re-run the boiler and the lime disk unloading. (2) Wet regimen: After Shutdown of the water discharge released, the internal completely remove the dirt, rinse, refill treated water to the full, the water was heated to 100 deg.] C oven, so that the water discharge gas outside of the furnace, then close all the valves, cold climates where moisture can not support the use of law, so as not to damage the boiler furnace water freezes.

In addition to long pauses use of gas-fired boiler burners for commercials to note the above operations, the daily maintenance is also very important and must be inspected once every few months we should note that the desiccant, promptly added; and each periodic inspection of boiler parts usage, have something to damage should be repaired or replaced.